You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Iron Butt
Posts: 741
Central New York | Got a set of Lower Deflectors to install but the instructions don't give a temperature tolerance for the adhesive. Anybody seen anything on this? Anybody tried this in colder weather? |
|
| |
|
Iron Butt
Posts: 935
Rockford, IL |
Take a look here http://www.vision-riders.com/bb/forums/thread-view.asp?tid=1689&pos...
And here http://www.vision-riders.com/bb/forums/thread-view.asp?tid=2020&pos...
About the only rule you MUST/SHOULD/BETTER follow is to WAIT the 24 hours !!! |
|
| |
|
Puddle Jumper
Posts: 15
Newbury Park CA | Don't glue them, take the time and bolt them on. They will only come off if you want them too. |
|
| |
|
Iron Butt
Posts: 1158
Richmond, Virginia | Ive put on two sets. Neither have come off. Make sure you use the alcohol prep and remove all the wax off the panel. Then take a blow dryer and warm up the plastic where the adhesive will attach. Once you place the deflectors in the proper position LEAVE EM ALONE, dont open close open close open close for 24 hours. After that THEY WONT COME OFF. |
|
| |
|
Cruiser
Posts: 266
Stockton, Ca. | Cleaning with the alcohol prep and allowing 24 hour cure time is the key. I have mine on for 2 years and they are as sturdy as they were day 2, after the 24 hour wait. |
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2025 Victory Riders Network™
|
|
Lower Deflector Adhehesive
