You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Puddle Jumper
Posts: 15
Quincy Massachusetts | You can use the heel-toe shifter from a Kingpin with a very minor modification to create a heel-toe shifter on your Vision. You just need to slightly modify the shifter mount bracket to clearance the Kingpin shifter, and then it will fit right on. Adjust it and you are set to go. I have been riding it for 1500 miles with no problems. |
|
| |
|
Puddle Jumper
Posts: 8
cambridge springs pa | Long Will, Do you have to file the mounting bracket a little or the shifter? Ward. |
|
| |
|
Puddle Jumper
Posts: 15
Quincy Massachusetts | Hi
Yes you need to slightly machine the bracket for clearance.
Follow this link for a diagram, the red lines indicate where clearance is necessary.
http://mysite.verizon.net/vzeq9ctx/sitebuildercontent/sitebuilderfi...
Regards
Long_Will |
|
| |
|
Cruiser
Posts: 257
Under the Rule of Jedi - Masshole | Long Will... Someone was asking about this, I was going to give him your link to the pfd file. Seems it's not working anymore. |
|
| |
|
Tourer
Posts: 388
Salisbury, NC | Long Will, All I did was move the shifter back to the 1st hole and cut a 1/4" off each end of the shift rod. Been working fine for 3000+ miles. ET |
|
| |
|
Cruiser
Posts: 266
Stockton, Ca. | Any chance we can get that link working again? I would like to give it a try also... |
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2024 Victory Riders Network™
|
|
Vision Heel Toe Shifter - Installed
