You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Puddle Jumper
Posts: 47
Lake Park, GA | I modified a Genie remote for my garage door and needed switched power. After digging around a bit under the front valance (metal trim) I followed the power wire from the center headlight (the switched light on the center console) and low and behold, there is a switch power lead and ground right in front - VERY accessible.
If you pull off the valance, look for a two wire plug directly up front that has a black wire and a pink wire with a green stripe. The plug has a rubber cap on it.
I tapped into the pink/green wire for 12 volt power, the black wire for ground. (or you could ground to the aluminum frame up front)
I suspect that this plug is for aux. lights.
So now i flip the center light switch on the console and the garage door opens and closes :-)
I hope this helps if switched power is needed. |
|
| |
|
Visionary
Posts: 2026
Brighton, TN | You want to give up how you did this, with the garage door opener. |
|
| |
|
Puddle Jumper
Posts: 47
Lake Park, GA | Sure will ... let me get some info together and I'll post it up. |
|
| |
|
Cruiser
Posts: 196
| Stuart,
I, too would like to see how you did this!
Thanks!
Bill |
|
| |
|
Cruiser
Posts: 293
Arkansas | Just a question: For those who have the premium tour; I guess the voltage is picked off that switch before
it is stepped up to mega volts for the HID. Gut tells me 12V. Does it make a difference when flashing the HID?
Is it ok to do that w/o affecting reliability?
|
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2024 Victory Riders Network™
|
|
Switched power
