You are currently not logged in.  Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.

Search:




lighted badge fell apart?
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   Discussion -> Vision DiscussionMessage format
 
taz456
Posted 2017-06-25 5:52 AM (#192031)
Subject: lighted badge fell apart?


Cruiser

Posts: 214
Pittsburgh, PA

This morning's ride to work went fine. When I was dismounting, I noticed the left side lighted badge was flickering. I did what cames naturally and flicked my middle finger against my thumb snapping it at the lense. After a few snaps the "chrome" frame come undone and the LED badge hung down with the wiring keeping if from hitting hte ground. 

I searched the forum and found that there has been issues with the left side flickering and/or not lighting. I get that and will deal with it but does anyone know what holds this unit together? There was a clear film under the frame but it is not a silicon caulk or like any other automotive trim adhesive that I am used to. 

 

Anybody have any thoughts or comments? I am hoping that the flickering is just a wiring issue and it soulnd like it is up by the fuel box according to the other posts. If I am successful at getting it lit right, what options to have it hold it self together? 

 

Top of the page Bottom of the page
johnnyvision
Posted 2017-06-25 5:49 PM (#192033 - in reply to #192031)
Subject: Re: lighted badge fell apart?


Visionary

Posts: 4199
use some clear silicon if you use glue it will just fall off again.
By the way vic discoed them about 8 years ago
Top of the page Bottom of the page
X-Magna
Posted 2017-06-26 1:56 PM (#192036 - in reply to #192031)
Subject: Re: lighted badge fell apart?


Puddle Jumper

Posts: 12
Birmingham, AL United States
My right side lighted badge on my 2011 did the same.. My wire was still connected so I just used silicone to reattach it.
Top of the page Bottom of the page
dkelly
Posted 2017-07-26 2:27 AM (#192129 - in reply to #192031)
Subject: Re: lighted badge fell apart?


Puddle Jumper

Posts: 13
Another vote on using clear silicone. Just let it dry for 24hours.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

Copyright © 2007-2017 Victory Riders Network™