|
|
Cruiser
Posts: 154
| Can someone please tell me how far the windshield moves up and down? Does it go from full size(all the way up) to blade size (all the way down)?
Thanks,
Shane |
|
| |
|
Cruiser
Posts: 223
Valdosta, GA | The motor will allow the windshield to move about 1 inch lower than the lowest stock position. It will move up to where the top of the shield is above my head. |
|
| |
|
Iron Butt
Posts: 619
Southeast Iowa | If I remember correctly the windshield has 4 inches of travel. If it is still too high or too low you can buy a taller or shorter one. |
|
| |
|
Iron Butt
Posts: 849
, FL United States | I got the "tall" windshield installed on my Vis when it was delivered. I'm thinking about getting a taller one made for me, as it just doesn't feel right. I get a "crick" in my neck from "crunching down" to keep my helmet out of the buffeting. I guess I'm too tall in the saddle lol |
|
| |
|
Cruiser
Posts: 293
Arkansas | 3.5 inches is the range, I believe- read it somewhere. Has a little front
to back component to it too. |
|
| |
|
Cruiser
Posts: 76
| I'm a midget at 5' 7" and the stock shield is perfect for me. At the lowest point I get a nice "in your face feel" without to much wind. At the highest point I am totally protected from the wind. |
|
| |
|
Cruiser
Posts: 154
| Thanks everyone!
Shane |
|
| |
|
Cruiser
Posts: 74
MN. | If you like them low, you have to spring for the blade. I rode one with it, I didn't like it as much as the standard, air management wise, but it looks cool. |
|
| |
|
Visionary
Posts: 1484
LaPorte,Tx. | shane6727 - 2008-02-05 3:04 AM
Can someone please tell me how far the windshield moves up and down? Does it go from full size(all the way up) to blade size (all the way down)?
Thanks,
Shane
Using my trusty square edge and Lufkin tape, the full travel on a standard is 3.5". |
|
| |
Electric Windshield question
