You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Puddle Jumper
Posts: 9
| I had JBL speakers in the front and stock in the rear. I could hear the front but not really the rear. I upgraded my front speakers to alpines because i blew a jbl. and witchdoctor sells Alpines. Now i can hear the stock rears better than the front? |
|
| |
|
Tourer
Posts: 366
Albuquerque, NM | Adjust the fader control?
Or
Stock speakers are 2 ohm I believe. The alpines are probably 4 ohm and require more power to drive them. Your best bet is to replace the stock rears with 4 ohm speakers and add an amp. Or, replace the fronts with another set of 2 ohm speakers and no amp will be needed. |
|
| |
|
Tourer
Posts: 366
Albuquerque, NM | Adjust the fader control?
Or
Stock speakers are 2 ohm I believe. The alpines are probably 4 ohm and require more power to drive them. Your best bet is to replace the stock rears with 4 ohm speakers and add an amp. Or, replace the fronts with another set of 2 ohm speakers and no amp will be needed. |
|
| |
|
Puddle Jumper
Posts: 9
| Thank you for your reply. I dont think i will change them it was to hard to get the little rubber gromments to stay in. Might have to install an amp. |
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | stock speakers are 3.8 ohms. (4) make sure you matched the impedance.. also
look at this... sensitivity rating http://www.audioholics.com/loudspeaker-design/loudspeaker-sensitivi...
Edited by Arkainzeye 2015-10-06 8:36 AM
|
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2024 Victory Riders Network™
|
|
speakers
