|
|
Puddle Jumper
Posts: 30
Paragould, AR | My Vision has a whine from the rear when I am going around curves. The faster I go or more lean angle I have it is louder. It is quiet otherwise. Anyone have any ideas what it could be? The bike has 2300 miles on it.
Thanks |
|
| |
|
Iron Butt
Posts: 623
| i have the same sound at the same time. I contributed it to harmonics radiationg off the ashpault, since its much more noticeable on the pully side.....hope I am right |
|
| |
|
Cruiser
Posts: 87
Lusby,Md | Check the outside edge of the tire you might find tire cupping . |
|
| |
|
Cruiser
Posts: 68
Cabot Arkansas | it is belt noise mine is doing the same thing, also i have noticed the same noise around 50-60 mph going straight and it is worse riding 2 up |
|
| |
|
Cruiser
Posts: 141
| Tires...left side is worn to no grooves hence no sound. Right side still has some and there is harmonics on right turns. |
|
| |
|
Cruiser
Posts: 212
Tavares, Fl | I just replaced my rear tire and I have the whine, never noticed it before. I noticed mine at slow speeds.... |
|
| |
|
Puddle Jumper
Posts: 30
Paragould, AR | I don't notice any at low speed, I think it starts around 45-50mph. I hope it is not the tire, not had the bike for 2 months yet. I will play with the belt adjustment and see if that will help. Back to work tomorrow so it will have to wait. I am running 40psi, no cupping. |
|
| |
|
Tourer
Posts: 550
Tacoma, WA | Its the tire. No worries. The more miles you get on it, the more pronounced on corners it will be. Put on loud pipes, and it will go away. My tire at 17,000 miles still does it.-------Metalguy. |
|
| |
|
Cruiser
Posts: 297
VA | Glad someone asked this, I just noticed this a few weeks ago and thought I was going nuts because I had never heard it before. Makes sense though. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | Very characteristic of the Dunlop E3 to the point I heard folks complain about it. Me? I like it on mine, no problems and it lets me know as long as they are whining, I won't be... |
|
| |
|
Puddle Jumper
Posts: 37
Kewaskum, WI | I had this issue last year. Turned out to be the belt (too tight). |
|
| |
|
Puddle Jumper
Posts: 20
Fort Myers, FL United States | I have noticed a pronounced whine/howl at low speed since about 4,000 miles. Dealer mechanic said tire cupping is the cause. The wear doesn't seem very uneven except for the raised center ridge that appeared on both front and rear. I've read Dunlop says this ridge occurs due to their use of a harder rubber compound in the center. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | crna63 - 2009-04-26 1:22 PM My Vision has a whine from the rear when I am going around curves. The faster I go or more lean angle I have it is louder. It is quiet otherwise. Anyone have any ideas what it could be? The bike has 2300 miles on it. Thanks Now that I think of it, I do get a high pitch whine when riding two up, especially the faster I go in the lean. Sometimes it turns into a loud thumping noise in my helmet as well as "If you don't slow this thing down now I'm never riding with you ever again.."  |
|
| |
|
Tourer
Posts: 576
, IA | yep the noise is coming from the rear seat not tire wonder what that could be lol |
|
| |
|
Puddle Jumper
Posts: 20
Fort Myers, FL United States | You're right varyder. I get that same high speed whine and thumping too--only when riding two up. Dealer says that's normal for the Visions. |
|
| |
|
Iron Butt
Posts: 1117
Northeast Ohio | I just removed my Ness Big Honkers after Daytona this year and noticed the whine when I went to S1L1. I also remember reading that the GoldWings have these tires too and have the same sound.
+1 for metalguy, if you want the noise gone, drown it with a loud pipes.  |
|
| |
|
Iron Butt
Posts: 1117
Northeast Ohio | I also have some scalloping / cupping on my tires. This is normal wear and an indicator of the tires working. A good read on tire wear over here: http://www.rattlebars.com/valkfaq/tirewear/
|
|
| |
|
Iron Butt
Posts: 1117
Northeast Ohio | Edited for duplicated post.
Edited by ScoreBo 2009-05-01 9:17 AM
|
|
| |
|
Puddle Jumper
Posts: 24
savannah ga | yup E3's will whine on turns ,the harder you lean them they more the talk. my goldwing as stated did the same thing and the vision has started it . I inspected the tires to see slight cupping very hard to see at the early stage but will get easyer to see as miles rack up . A belt on these beast talk to as well but not the same sound i have had both problem the belt comes and goes as the weather changes . Oh the rear seat will whine and thump as well under fast and fun riding.lol |
|
| |
|
Iron Butt
Posts: 1117
Northeast Ohio | I occasionally get a karate chop too. I am seeing if there is a recall on this. |
|
| |
|
Cruiser
Posts: 266
Stockton, Ca. | I have a high pitched whine only at high speeds. No tire cupping, in fact they are wearing very well so far. It only happens when I am riding two up. It turns out the whining is my wife shouting to slow down! |
|
| |
|
Tourer
Posts: 329
scotts valley, California | Yah, I generally leave my high pitched whine at home!
I've had the bike serviced in Seattle, Rapid City, and Pleasenton, and got three different ideas on the ideal belt tension. It squeeks or squeels somewhat no matter what the tension. Belt dressing helps as do the Ness mufflers. |
|
| |
|
Iron Butt
Posts: 623
| i had belt squeeks, the guys in Cumming Georgia got a new pully, put it on under warrenty, and I've had not a sound out of it after 4000+ miles. The dealer here in Cumming GA has to be one of the best. |
|
| |
|
Tourer
Posts: 329
scotts valley, California | Thanks, Jeffmack, I'll talk to the guys at Arlen's in Pleasanton about a new pulley. |
|
| |
whine from rear tire/bearings?
