You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Puddle Jumper
Posts: 43
| I need to remove the Pass. Grab Bars for painting. ? is, is it pretty obvious when I open the saddlebags or is there a trick to removal....
Scott.Morgan@adm.com |
|
| |
|
Visionary
Posts: 3006
San Antonio, TX | Here is one method described twice.....
Here is one with pictures....... http://www.vision-riders.com/bb/forums/thread-view.asp?tid=5227&pos...
Here Flatsix wrote.... http://www.vision-riders.com/bb/forums/thread-view.asp?tid=4223
I removed and painted mine and found the removal to be not bad. I removed the seat, license plate bracket, and panel around taillight. Unscrew the latches on your bags, remove 4 screws holding the computer down and the 4 bolts close to the computer. Loosen the 2 bolts inside the bags on the vertical panels and you can then move the base the computer mounts to from side to side and lift it up to get at the grab rail bolts very easily without cutting. Paint em and reverse the procedure.
Good Luck!
-----
John / Fargo, ND / 82 & Sunshine
Edited by radioteacher 2010-10-01 3:59 PM
|
|
| |
|
Iron Butt
Posts: 935
Rockford, IL | Another option...... http://www.vision-riders.com/bb/forums/thread-view.asp?tid=3428&pos... |
|
| |
|
Visionary
Posts: 3006
San Antonio, TX | Lotzafun,
Thanks! I knew there was another way but I could not find your post.
Ride Safe! |
|
| |
|
Puddle Jumper
Posts: 43
| Thanks all. it should be doable,,, even with limited mechanical aptitude...  |
|
| |
|
Cruiser
Posts: 169
Iowa | I just took the Vision apart for painting and I followed these instructions for the grab rails. It worked perfect. No cutting needed. Thanks for sharing. Now off to the painter. |
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2024 Victory Riders Network™
|
|
VV Grab Bar removal
