You are currently not logged in.  Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.

Search:




Lash Learn Procedure for a 2010 XC Cruise Control?
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   Discussion -> Cross Country / Cross Roads Tech Q&AMessage format
 
rdeerx
Posted 2011-02-15 3:35 PM (#79383)
Subject: Lash Learn Procedure for a 2010 XC Cruise Control?


Puddle Jumper

Posts: 19
Can anyone give me the "Lash Learn Procedure" for the 2010 XC cruise control. Thanx in advance
Top of the page Bottom of the page
Jedi Jeff
Posted 2011-03-11 1:34 PM (#81194 - in reply to #79383)
Subject: RE: Lash Learn Procedure for a 2010 XC Cruise Control?


Fountain Inn, SC United States
For those that don't know, the Learn Lash Procedure is the order of adjustments/steps you run thru if your cruise control is acting erratic.

Based on his answer from another forum thread, here's what Kevinx shared:

1-Press & hold the resume & on/off buttons on the cruise control switch.
2-Turn the ignition switch on.
3-While holding both buttons, start the engine.
4- After the engine starts, watch the cruise indicator lamp on the indicator display until it goes out.
5-When the cruise control lamp goes out, release both buttons at the same time.
6-Press & hold the resume . the cruise indicator lamp should illuminate.
7-Listen for a brief increase in engine RPM(very slight RPM increase)as the cruise control module performs the procedure.
8- Release the resume button when the RPM drops down to idle speed & turn off engine.

The procedure is used when replacing the cruise control cable. The procedure takes any slack or free play out of the cruise cable where it connects to the throttle body.

Top of the page Bottom of the page
stretch
Posted 2011-03-29 7:47 PM (#82716 - in reply to #81194)
Subject: RE: Lash Learn Procedure for a 2010 XC Cruise Control?


Puddle Jumper

Posts: 47
Adamsville, Tn
worked on my 08 vision. Doesn't work on my 11 xc. cruise light never goes out at step 4
Top of the page Bottom of the page
Jbravo
Posted 2011-05-25 9:04 PM (#87153 - in reply to #79383)
Subject: Re: Lash Learn Procedure for a 2010 XC Cruise Control?


New user

Posts: 1
I think it must be different on the X-country cuz my does the same. I downloaded a copy of the service manual and its is not in there. It only shows you how to put it in diagnostic mode. Which is similar to the lash lean procedure so it goes into that. The light never goes out and then when released it flashes and it flashes faster as the rpms go up. This is to test the rpm sensor part of the cruise control.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

Copyright © 2007-2024 Victory Riders Network™