You are currently not logged in.  Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.

Search:




lite bar
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   Discussion -> Vision DiscussionMessage format
 
vic2004-08
Posted 2009-10-30 9:21 PM (#46820)
Subject: lite bar


Cruiser

Posts: 87
Lusby,Md
Just installed the brake/turn signal light bar from Custom Dynamics,installed it just under the trunk lid.Installation was pretty easy,had to extend the wires a little so they would reach the harness.Looks and works great.Saw pictures from another person that posted it .Extra lighting can't hurt!
Top of the page Bottom of the page
DAL
Posted 2009-10-31 1:42 AM (#46829 - in reply to #46820)
Subject: RE: lite bar


Cruiser

Posts: 60
Vancouver, B.C. & La Quinta, CA
Do you have any photos?
Top of the page Bottom of the page
vic2004-08
Posted 2009-10-31 10:25 AM (#46833 - in reply to #46820)
Subject: RE: lite bar


Cruiser

Posts: 87
Lusby,Md
A picture from another post.



(Tank LEDS.jpg)



Attachments
----------------
Attachments Tank LEDS.jpg (45KB - 1 downloads)
Top of the page Bottom of the page
Amibrau
Posted 2009-10-31 11:13 AM (#46834 - in reply to #46833)
Subject: RE: lite bar


Cruiser

Posts: 52
The Great Northwet
Robert,
Kinda looks like you put it in the gap between the lid and trunk? Or is it on the trunk itself? Any additional info like part number from Custom Dynamics, additional pictures, etc. would be greatly appreciated. I have a similar light bar that I bought a couple of years ago and never installed so this could really give me leg up before I install. Thanks.
Top of the page Bottom of the page
vic2004-08
Posted 2009-10-31 4:45 PM (#46837 - in reply to #46820)
Subject: Re: lite bar


Cruiser

Posts: 87
Lusby,Md
I put it between the gap of the trunk lid and trunk,drilled small holes in the inner lid to run the wires inside the lid and out the right hand trucklid hinge.Had to add wire so the wires would reach the wire harness on the right side underneath the seat.In the kit there is a splitter so you can run a running light,but I didn't use it.Black is ground,white/red is the brake lite ,blue is the left turn signal,blue/pinkis the right turn signal and green/pink is the running lite.And if you go to Custome Dynamics .com the item number is -- ST6126ARA,6 amber on each side and 12 red in the middle.If you look at one of the past post about people asking questions about the Kuryakin light hook up to make the trunk lights turn/brake lights another guy had more pictures of this.Hope this helps.
Top of the page Bottom of the page
Amibrau
Posted 2009-11-01 11:02 AM (#46867 - in reply to #46837)
Subject: Re: lite bar


Cruiser

Posts: 52
The Great Northwet
Thanks, good info.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

Copyright © 2007-2024 Victory Riders Network™