|
|
New user
Posts: 4
Rochester, NY United States | (I also have this posted in the "Vision Discussion" Forum.) This is my first time looking for help on this site, I hope I'm posting this in the right place. I have 2013 Vision with reverse. The problem I'm having is the reverse works while on level ground but "clicks" out when encountering any resistance. I pulled the reverse motor off to check the keys as suggested in the service manual but they were fine. The manual doesn't give a whole lot of information on removing the gear drive side which must be where the problem lies. Does anybody have a similar experience or suggestions on what to look for? Any help would be greatly appreciated. Thanks, Scott. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | a closer look will probably lead you to rebuilding or replacing. I don't know your overall situation, but having knee problems I always ensure I park for an easy egress. That's my two cents and now I'm broke. |
|
| |
|
New user
Posts: 4
Rochester, NY United States | The motor seems to be fine. Something on the right side is slipping out of engagement on the right side. Unfortunately the manual doesn't go into much detail for this side of the unit. |
|
| |
|
Puddle Jumper
Posts: 8
Columbia Co, WI | reverse linkage rod adjustment may need to be lenghtened |
|
| |
|
Cruiser
Posts: 92
| it's been a few years since I installed mine, but I remember the drive gear resembling something out of a cracker jack box. I have a lip of about two inches to get up in my garage... my reverse will NOT pull the bike up that lip. I don't have any gear slippage (at least not that I can hear) it just hasn't got the balls to lift 900 pounds up a 2" lip.
I'm sure I still have the installation instructions so if you can't figure it out let me know and I'll dig them up to see how to get you where you want to go. |
|
| |
|
New user
Posts: 4
Rochester, NY United States | If you could find those instructions and e-mail them to me, that would be awesome. This will now be a winter project since summer is nearing its end. (miscnv@live.com) Thanks. |
|
| |
|
Puddle Jumper
Posts: 8
VA Beach | I had the same problem. 804 Motorsport in VA adjusted it. No issue. |
|
| |
|
New user
Posts: 4
Rochester, NY United States | I do still need them if you have them. My email is miscnv@live.com. Thanks |
|
| |
|
Cruiser
Posts: 154
Danbury, Connecticut | http://www.thevog.net/threads/reverse-kit-installation-instructions... see post #11 for the downloadable PDF file |
|
| |
Reverse doesn't like resistance
