|
|
Puddle Jumper
Posts: 7
Endicott, NY 2011 Vision | I'm trying to drill a hole in my Vision panel for the Garmin 660 harness to go through. It calls for a #16 metric drill. Seeing that I don't have such an animal would anyone know what the equivalent size a standard bit might come close? Thanks for your reply. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | 5/8 |
|
| |
|
Cruiser
Posts: 208
Edmonton Alberta, Canada | As Varyder said, 16mm = 5/8", only hoping they are not asking for number drill bit size. I have a chart at work for that but am sure there would be a google site to convert. |
|
| |
|
Visionary
Posts: 1229
Rancho Cucamonga, CA | 5/8" is huge! Make sure that's what you want to do, it will be hard to cover that up if it's wrong.
Is that going under the Vision's GPS accessory bracket?
I am using a RAM mount, so I chose to drill a much smaller slot thru the key bezel. This way I would not need to drill a large hole in my dash and the bezel would be much cheaper to replace.
(2012-05-25 21.25.58.jpg)
(2012-05-25 21.32.03.jpg)
Attachments
----------------
 2012-05-25 21.25.58.jpg (63KB - 2 downloads)
2012-05-25 21.32.03.jpg (61KB - 0 downloads)
|
|
| |
|
Cruiser
Posts: 215
Boydsville, AR United States | Now that is one cool neat idea to get the cable up, and be neat. Cheep to put back to stick too, if you sell. |
|
| |
|
Visionary
Posts: 4278
| this will help and are you sure on the 16mm
http://www.boltdepot.com/fastener-information/Metric-Tap-Drill-Size... |
|
| |
|
Iron Butt
Posts: 849
, FL United States | Darrell, you rock! What a neat and functional modification. |
|
| |
Help-------
