|
|
Visionary
Posts: 4278
| I have a 08 vision and would like to wire in a tip over sensor. ( hope to never use)
Where does Vic put it?
Do you think its possible?
Thanks to every one and if you do reply what wires would be used. Dealers scared to even talk about how to. |
|
| |
|
Cruiser
Posts: 156
dinwiddie, va | It would actually be easier then you think. You can get the angle sensor and wire it in after your kill switch. I will look at an 08 manual when I get back to shop on Monday and see what wires you can use. I will check out stock location, but you could mount it anywhere. I would stay around rear of motor or front of swingarm around brake line switch. I have actually installed some on older bikes and drag bikes hat didn't have lanyards |
|
| |
|
Visionary
Posts: 4278
| Great I could put it in one of the saddlebag pockets. I have looked on ebay and there not very big and it looks like 5 wires.\It just scares me if the bike goes and stays running. In the back of my mind I keep think they highway safety board pass a law back in 05. But then I think about a lot of stuff thats not there.
Thanks for your help |
|
| |
KevinX or any one tip over sensor