|
|
Puddle Jumper
Posts: 29
| A large bug got embedded inside my clutch lever . So I started to clean it out, but bug goop got on the inside of lever. So I took out the bolt that holds the lever & barley moved the lever & the entire lever came off including the tip of the cable. Can this be put back on. Or did it break at the right time ( sitting in my driveway ) Any help would be greatly appreciated. 08 vision 13500 miles
Craig |
|
| |
|
Visionary
Posts: 1290
Ruskin, Fl | It is not a cable. The Vision has a hydraulic clutch. Looking at the manual, what you are calling the "tip of the cable" must be the push rod. I am e-mailing you a screen shot of that page of the manual. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | ...you have an 8-ball? |
|
| |
|
Puddle Jumper
Posts: 29
| Sorry, not cable end , but push rod fell out. Do you have replace the slave cylinder. |
|
| |
|
Visionary
Posts: 1290
Ruskin, Fl | I haven't taken mine apart, but I gonna say no. Just went and looked at it. A dab of grease should hold that push rod in place while to get the lever back on. If not just use the lever to hold it there and pivot on the push rod till you get the bolt hole to line up. Did you get my email? |
|
| |
|
Puddle Jumper
Posts: 29
| Dang, Do I fell like a DUMB A .. My first hydro clutch. I put push back in & everything works great.
Daaaaaaaa |
|
| |
|
Puddle Jumper
Posts: 29
| Thanks CW1115 for your response .No more spraying lacquer before i work on anything .
Thanks again |
|
| |
clutch cable