|
|
Puddle Jumper
Posts: 28
Basehor, Ks. | Ok-here I go.
Why are cam installation instructions on the Vision such an evasive secret?
Hey, I live in KC and nobody is going to have a cam party in this cowtown, so I need
to do this myself. I do not understand why Lloyd does not publish instructions like
Andrews. I mean, it's not like I am going out to sell myself as a professional Vision
cam installer. I dare you to post your experience if you have done this. That goes for
especially Llyoyd and Kevin-X.
Most absolutely respectfully,
thenuz  |
|
| |
|
Puddle Jumper
Posts: 44
| Everything you need to do the job is in the service manual. If you have an 09 or 10 bike then you have to change cam carriers. I changed them on my 09 and it really was not that bad. I ended up with the same results, but I looked like an ass compared to how quick that Kevin or Lloyd could change them.
You just missed Kevin in Omaha, but Lloyd is going to do cam changes at the AVR. Your other option is Rylan Vos who is located in Des Moines. |
|
| |
|
Cruiser
Posts: 203
Rapid City, SD | I am moving to the KC area in August. I scheduled myself a cam appointment during the AVR up in Iowa. If you can wait that long that might be a good option. |
|
| |
|
Visionary
Posts: 1340
Gainesville Fl Home of the Gators | No secret to it. I have taught dealers, and individual techs my method. Simply put I type with three fingers, and don't have the patience to write out a lengthy instruction sheet
Edited by kevinx 2010-05-01 5:57 AM
|
|
| |
|
Tourer
Posts: 576
, IA | rylan.vos@gmail.com or phone 402-659-9655
-----
------------Rylan---------------------------
------------The Vic Shop-------------------
------------Minburn, Iowa-------------------
------------402-659-9655-------------------
rylan.vos@gmail.com or phone 402-659-9655
-----
------------Rylan---------------------------
------------The Vic Shop-------------------
------------Minburn, Iowa-------------------
------------402-659-9655-------------------
he does it and he is close to u check out thevmc.com |
|
| |
|
Cruiser
Posts: 169
The Vic Shop - Central Iowa | I'm actually passing through KC on Wed May 5th to do a set down south of you. Look me up I could give you some pointers......
-Rylan- |
|
| |
|
Cruiser
Posts: 71
Willmar, MN | Question for Kevin or Rylan...is a fuel controller necessary for new cams. If it is, where are you finding the lean spots. |
|
| |
Cams