Rear CB Connection

ScoreBo Posted 2010-03-11 7:58 PM (#54867) Subject: Rear CB Connection Iron Butt Posts: 1117 Northeast Ohio So I am installing a CB on Vision and got to step #30. Any help understanding where to drill the hole would be appreciated. Edited by ScoreBo 2010-03-11 8:02 PM ScoreBo Posted 2010-03-11 8:12 PM (#54869 - in reply to #54867) Subject: Re: Rear CB Connection Iron Butt Posts: 1117 Northeast Ohio Whoever did these instructions should be fired. Step #28 is actually step #30 as Step 28 says. "Flex and remove the trunk floor panel and retain for reinstallation." It is absolutely the worst instructions I have ever seen. I think some of the Chinese instructions are better than this. Who proof reads this stuff? ScoreBo Posted 2010-03-11 8:42 PM (#54871 - in reply to #54867) Subject: Re: Rear CB Connection Iron Butt Posts: 1117 Northeast Ohio It appears that step 29.5 is missing - Remove seat filler panel so you can see the dimple. Lone Ranger Posted 2010-03-12 6:49 AM (#54897 - in reply to #54867) Subject: Re: Rear CB Connection Tourer Posts: 447 Cleveland, GA Here's a post I made of how-to's back in Dec '08 when I installed mine: http://www.vision-riders.com/bb/forums/thread-view.asp?tid=338&post... ScoreBo Posted 2010-03-12 6:59 AM (#54898 - in reply to #54867) Subject: Re: Rear CB Connection Iron Butt Posts: 1117 Northeast Ohio I wish I would have found your write-up first. I think I would rather put together a house full of IKEA furniture before I do this again. radioteacher Posted 2010-03-12 7:37 AM (#54900 - in reply to #54867) Subject: RE: Rear CB Connection Visionary Posts: 3006 San Antonio, TX Here is what my old dealer did with my rear switch. They used some type of RTV to glue the switch in. I no longer wonder how they went out of business. Edited by radioteacher 2010-03-12 7:38 AM (GluedRearSwitch.jpg) Attachments ---------------- GluedRearSwitch.jpg (58KB - 2 downloads) chesshiretuna Posted 2010-03-13 7:53 AM (#54945 - in reply to #54867) Subject: RE: Rear CB Connection Tourer Posts: 390 That's why I let the dealer install mine.....I saw another in mid-install and decided that taking my new bike appart for this was not one of the first things I needed to do ScoreBo Posted 2010-03-13 8:54 AM (#54947 - in reply to #54897) Subject: Re: Rear CB Connection Iron Butt Posts: 1117 Northeast Ohio Lone Ranger - 2010-03-12 6:49 AM Here's a post I made of how-to's back in Dec '08 when I installed mine: http://www.vision-riders.com/bb/forums/thread-view.asp?tid=338&post... Lone Ranger, #34 under module installation. I 100% agree with your post (looks like it can't be replied to anymore). I installed the CB module and bottom bolt when I had the trunk skin removed to install the antenna. It is IMPOSSIBLE to install this any other way.