|
|
Cruiser
Posts: 244
Lindale, TX | Just finnished washing bike. Oil Pressure Light stays on after engine starts. I checked oil and its right at full. I have 3084 miles on the Vision and changed over to AMSOIL at 500 miles. Shut off the bike and headed here.
Edited by Easttexasrider 2009-07-22 8:48 PM
|
|
| |
|
Cruiser
Posts: 244
Lindale, TX | Okay, my good friend TEACH reminded me this can happen after washing the bike. |
|
| |
|
Visionary
Posts: 3006
San Antonio, TX | Happens to me as well. When it gets wet it reads low pressure.
Ride Safe |
|
| |
|
Visionary
Posts: 1324
So Cal | The wire that goes to the switch comes real close to the exhaust. Make sure it didnt burn and ground out. I took my little rubber cover off (it was burnt from the exhaust) an option for warmer climate bikes. |
|
| |
|
Visionary
Posts: 1484
LaPorte,Tx. | I clean and put die-electric grease on the connection under the rubber cover, and do this probably 3 times a year. Have not had the false oil pressure issue. |
|
| |
HELP Dealer 120 miles away