|
|
New user
Posts: 4
| Was going to install the passenger floorboard risers but can not seem to get the tiny circlip off. They say to use snap ring pliers but all mine are for snaprings with eyes and these are a solid ring around the pin in a groove. Wasn't able to get under it with a pick or small screw driver.
Any help would be greatly appreciated! |
|
| |
|
Cruiser
Posts: 154
Danbury, Connecticut | Mine might be different but it looks like the clip with eyes with half the eye removed and could still use a very small pair of clip pliers. I know there are clips that have no means of using pliers and I use a small pair or needle nose on each side and push it off-pliers and clip aligned on same plane. Cover with a rag or tape to keep the clip from flying away. |
|
| |
|
Visionary
Posts: 4278
| pry off clip. take pin and go to hardware store and buy new C clip.
A slight bend in old clip from getting it off will not hold pin in long run |
|
| |
Any tips to getting the snapring off .....