Visionary
Posts: 1290
Ruskin, Fl | This did not come out as well as I planned, but it works perfectly. I put grease on a broken drill bit and tried to build up the JB Weld around it and then pull it out. That did not work, the epoxy stuck to it like tar and I was afraid it would be impossible to remove. I just put a glob of epoxy down, drilled it out and shaped it with a Dremel.
(IMG_8062.jpg)
(IMG_8064.jpg)
(IMG_8044.JPG)
(IMG_8048.JPG)
(IMG_8068.jpg)
(IMG_8047.jpg)
(IMG_8047.jpg)
(IMG_8070.jpg)
Attachments
----------------
 IMG_8062.jpg (137KB - 5 downloads)
IMG_8064.jpg (153KB - 2 downloads)
IMG_8044.JPG (75KB - 1 downloads)
IMG_8048.JPG (67KB - 1 downloads)
IMG_8068.jpg (119KB - 1 downloads)
IMG_8047.jpg (126KB - 1 downloads)
IMG_8047.jpg (126KB - 2 downloads)
IMG_8070.jpg (141KB - 2 downloads)
|