|
|
Fountain Inn, SC United States | Anyone have an idea where I can get the special body screws used all over the Vision, other than from Victory? |
|
| |
|
Tourer
Posts: 548
Mount Vernon, WA United States | I don't have a Vision, but what do the screws look like? McMaster Carr may be a good source. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | Fastenal might have them also. |
|
| |
|
Cruiser
Posts: 79
Louisville, KY | Yeah that stuff is hard to find. I have a small amount of the screws and the clips they go into. pm me and I can get you some. |
|
| |
|
New user
Posts: 3
| I just picked up 2 bags of four from NAPA. He even mentioned a tool for removal. I just use a flat tip of the correct size. The velcro that holds the netting to the saddle bag doors let go from the Florida heat when parking in the sun. I am going to use them to additionally secure the new velcro. NAPA has just about every type of automotive fastener. Good luck. |
|
| |
|
Fountain Inn, SC United States | Here's a couple photos of the screws I'm trying to find.
McMaster Carr was close but not the same - not hex pan head, not black
Fastenal didn't have anything close. Too bad since there's a dealer about 10 miles from me.
Search will continue?
(vision_screw1.jpg)
(vision_screw2.jpg)
Attachments
----------------
 vision_screw1.jpg (50KB - 0 downloads)
vision_screw2.jpg (54KB - 0 downloads)
|
|
| |
|
Visionary
Posts: 4278
| there just a button head screw should be easy to find. Napa |
|
| |
|
Puddle Jumper
Posts: 6
| They are not just a button head screw. They have the shoulder so that when you tighten them down, you can't get to tight and crack the plastic.
Edited by sks700 2015-04-27 1:49 PM
|
|
| |
|
Visionary
Posts: 1290
Ruskin, Fl | I ordered a lot of bolts and screws from www.victorypartsrus.com. After the dealer finally got my bike together after 2 months all the original screws were replaced by whatever fit in the hole. Needed a dozen different tools instead of 3 to take body work off. I made everything back to factory. |
|
| |