|
|
Puddle Jumper
Posts: 21
| Hi guys,
I have a 2014 vision tour. Can someone please tell me the wire colors for the rear brake and directionals I need to tap into to add LEDS?
Pictures would be great!
Thanks,
Manny |
|
|
|
Puddle Jumper
Posts: 33 Sacramento, CA United States | Manny,
The common's BLACK/WHITE (BLACK wire with a WHITE stripe).
Left turn signal output's BLUE.
Right turn signal output's BLUE/RED (BLUE wire with a RED stripe).
Brake's WHITE or WHITE/PINK (depending on which lamp wire you're cutting into). Brake (or STOP as the manual refers to the indicator) WHITE wire goes to the MIDDLE STOP/TAIL LAMP while WHITE/PINK goes to the BOTTOM STOP/TAIL LAMP--take your pick.
When I added my LED license-plate frame to my '14 VV I double checked the wires leaving the associated lamp before I cut into the wire. The information I've provided is from the VV Service Manual (2008+ ). If you're going to replace the lamp with an LED and you're NOT using a plug-n-play (like MBW or exLED) then a trailer converter interface is recommended to "fake-out" the flasher's load requirements.
'ope this is the info. you're looking for....
Edited by Davet 2015-03-08 12:11 PM
|
|
|
|
Cruiser
Posts: 62 Eagan, MN United States | If you're looking to add just an led strip to augment the current lights the directions for the 99 led mod or the instructions from ljurgens have the information. I added the lights per ljurgens instructions to my 14 and they work great. I'd take a pic but my bike is 3 1/2 hours south in Rylan's shop
Edited by Rowebote 2015-03-08 11:50 AM
|
|
|
|
Puddle Jumper
Posts: 33 Sacramento, CA United States | From Manual:
(VV REAR LIGHTS.jpg)
Attachments ---------------- VV REAR LIGHTS.jpg (72KB - 7 downloads)
|
|
|
|
Puddle Jumper
Posts: 21
| Thanks guys,
I knew I came to the right place.
Peace and ride safe,
Manny |
|
|
|
Puddle Jumper
Posts: 21
| Thanks guys,
I knew I came to the right place.
Peace and ride safe,
Manny |
|
|