|
|
New user
Posts: 3
| Has anyone adjusted the shift lever on a 2013 Vision? I need to adjust the shift lever up to allow additional room for my riding boots. I would also like to move the shift lever back to decrease the reach. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | It should be the same on all models. You can move your controls fore or aft, there are 3 positions. On your linkage, adjust the turn link until you get it where you want. Your owners manual should tell you how. |
|
| |
|
Tourer
Posts: 573
Central Illinois | To move the lever back, just go underneath the floorboard and remove the positioning bolt. Slide toward the rear and insert the bolt into the next hole. After that move you will definitely need to adjust your pedal height. It will be way too high. Adjusting the shifter height is easy but not so easy if you have a heel shifter like I do. You simply loosen the lock nuts on the shift rod and twist it until the pedal is right where you want it, then tighten those lock nuts again. If you have a heel shifter the position needs to let you shift in both directions. Getting that right can be a bit tricky because the heel shifter and toe shifter must each move far enough to get a positive gear engagement. It took me 3 tries after I replaced my shift rod with a fancy decorative one. |
|
| |
|
Visionary
Posts: 4278
| dbennett - 2014-04-04 8:01 PM Has anyone adjusted the shift lever on a 2013 Vision? I need to adjust the shift lever up to allow additional room for my riding boots. I would also like to move the shift lever back to decrease the reach. Sounds like you never read your owners book. Its in there on how to. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | It's easier to adjust the controls than it is to change the rear tail lights or the head light. |
|
| |
Shift Lever Adjustment