|
|
New user
Posts: 3
Oakland, CA United States | Hello Forum,
I'm doing the Stingerz99 LED brake light install that's very popular for vision riders. Reading all the posts on this mod, all seems to be very simple.
The LED install went great, using Positaps for connection to the wiring, also very simple. I found the white/ pink and black wires to tab into. However, when I tap into these wires, the LED strip lights up and stays on without the key turned on and no brake applied.
I though I may have had the wrong wire, so I look into the other bundle of wires also coming out of the main connector. There's also a white/ pink and black wire in there. I try that one with the handy Positaps, and the same thing happens. The LED lights light up, the key isn't turned on, and the brake is not applied.
I've search all forum and all over the web. I've not found anyone else that has had this issue.
Is the 2012 vision wiring scheme different from the earlier models? If anyone could let me know what I've done wrong, or what the correct wire to use is, I would greatly appreciate it.
Thanks follow victory riders! | |
| | |
New user
Posts: 3
Oakland, CA United States | This post can be disregarded, I figure out my issue. I was totally using the wrong bundle of wires. My harm, just wasted a few sets of positaps. At least I know where all the hot wires are under the seat, for future mods. And they're tapped and ready to go.
Very easy mod, as long as you get the right bundle of wires. Looks great all lit up!
Thanks SongFan! | |
| | |
Visionary
Posts: 1229
Rancho Cucamonga, CA | Glad you figured it out.
Edited by Nozzledog 2013-12-15 11:13 PM
| |
| | |
New user
Posts: 3
Oakland, CA United States | yep, thanks! | |
| |
|
LED brake light install- lights stay on