erratic cruise contol operation fix
firehawk
Posted 2008-06-24 11:40 AM (#12312)
Subject: erratic cruise contol operation fix


Cruiser

Posts: 74
College Station, Tx

I got this from Mitch on the VMC and it worked great for me.

For those of you that are having problems with erratic cruise contol operation. Try this Cruise Control Cable Lash Learn Procedure:

1. Press and hold the resume and on/off buttons on the cruise control switch.
2. Turn the ignition key to on.
3. While holding both buttons, start the engine.
4. After the engine starts, watch the cruise indicator lamp on the indicator display
until it goes out.
5. When the cruise control lamp goes out, release both buttons at the same time.
6. Press and hold the resume button. The cruise control indicator lamp should
illuminate.
7. Listen for a brief increase in engine RPM (very slight RPM increase) as the cruise
control module performs the procedure. The cruise control lamp will go off during
this procedure.
8. Release the resume button when the engine RPM drops down to idle speed and
turn engine off.
This procedure is used when replacing the cruise control cable, but try it. Maybe it will help. This info is right out of the service manual and it states that failure to perform this procedure will result in erratic cruise control operation. This procedure takes any slack or free play out of the cruise cable where it connects to the throttle body.

Top of the page Bottom of the page
Mazman99
Posted 2008-06-24 1:51 PM (#12317 - in reply to #12312)
Subject: Re: erratic cruise contol operation fix


Puddle Jumper

Posts: 30
Bellevue, NE
So does this explain why when I am in cruise the bike surges and lurches when going uphill?
Top of the page Bottom of the page
firehawk
Posted 2008-06-24 3:09 PM (#12319 - in reply to #12317)
Subject: Re: erratic cruise contol operation fix


Cruiser

Posts: 74
College Station, Tx
Mine seems to still surge but not nearly as bad.
Top of the page Bottom of the page
VisionTex
Posted 2008-06-24 6:20 PM (#12330 - in reply to #12319)
Subject: Re: erratic cruise contol operation fix


Visionary

Posts: 1484
LaPorte,Tx.
I have noticed if mine surges, it is when set in 6th gear below 70 mph, like say 65. If I set the same mph in 5th gear it does not surge. And it really only does it on hills. So what I do, 5th gear below 70......6th gear above 70. No problem, also the Stage 1 Level 1 really sound sweet @ 65 in 5th.
Top of the page Bottom of the page
Web Mobile
Posted 2008-06-25 12:16 PM (#12371 - in reply to #12312)
Subject: Re: erratic cruise contol operation fix


Cruiser

Posts: 53
Island Lake, Alberta, Canada
Did the relash at the dealers, still surges going into load changes, eg: hills. Haven't tried 5th yet, but will.
Top of the page Bottom of the page