|
|
Tourer
Posts: 599
New Mexico | I was going to relocate my temp sensor (decided against it), and when I pulled off the front bezel I noticed this attached to it. I disconnected it and checked my radio reception and temp sensor, but appears everything still works.
Can anyone tell me what it is?
(Bezel1.jpg)
(Bezel2.jpg)
Attachments
----------------
 Bezel1.jpg (82KB - 0 downloads)
Bezel2.jpg (96KB - 0 downloads)
|
|
| |
|
Cruiser
Posts: 87
Lusby,Md | It's the radio antenna connection |
|
| |
|
Tourer
Posts: 599
New Mexico | Cool - Thanks!
|
|
| |
|
Visionary
Posts: 4278
| Now do your temp wire its easy to do. |
|
| |
|
Visionary
Posts: 1229
Rancho Cucamonga, CA | Your bike has two antennae, one goes down the inside of the right front fairing and the other is attached to the front access panel (the one you are asking about). You will still get FM reception if the front access panel antenna is disconnected, but AM and weather band will diminish. |
|
| |
|
Tourer
Posts: 599
New Mexico | Nozzledog - 2012-08-04 8:03 PM
Your bike has two antennae, one goes down the inside of the right front fairing and the other is attached to the front access panel (the one you are asking about). You will still get FM reception if the front access panel antenna is disconnected, but AM and weather band will diminish.
Thanks, that makes sense.
I didn't move the temp sensor because I was concerned about where to put it, and worried about breaking the bulb-like end or mounting clip. I did read a good write-up on it, but decided to just keep subtracting 3 from the readout.
Some good did come out of it - I found a new hide-a-key location 
|
|
| |