|
|
Puddle Jumper
Posts: 30
| When installing rear tip overs and floor boards on a 2011 Vision 8 Ball is there any issues with the pipes. I have seen some posts where there are issues with the pipe being in the way. |
|
|
|
Iron Butt
Posts: 935 Rockford, IL | Its been a long while since I removed mine to paint them but I'm pretty sure I remember needing to remove the pipes. |
|
|
|
Iron Butt
Posts: 880 Orlando, FL | Yes, I have said this before. THe Stock heat covers (the chrome pieces) on a 2011 Vision 8 Ball will need to be replaced with the same stlye as the Vision Tour. The pipes need a cutout at the tip over attachment point. So it's either replace that part of the heat cover, OR cut your existing heat covers and hope for the best (rust, poor cut, chrome flaking, etc).
If you have seen this post somewhere else, why are you asking again!?!?!? Just look at a Tour Vision to see the pipe difference. |
|
|
|
Iron Butt
Posts: 752 Broken Arrow, OK | MaddMAx2u - 2012-01-31 12:17 PM
If you have seen this post somewhere else, why are you asking again!?!?!? Just look at a Tour Vision to see the pipe difference.lol, now now Max, it's ok. Sometimes when we're new here we just like to post to get in on the group. You gave him a great answer until that last part! We see it all the time, posters asking lots of questions when a simple "google" could have answered everything. We can all just google stuff but that takes away from this whole Vision brotherhood! You know you could have easily just ignored the post rather than slamming him for asking.....just sayin. |
|
|