|
|
Cruiser
Posts: 232
| Well on my vtx1800, put power comander on have a disc that goes in laptop to set up. Does victory have a disc or some mean of reflashing their control units? |
|
| |
|
Tourer
Posts: 562
SC, Bluffton | Trell, I think only autorized Victory dealerships can do this. My Vision is running like crap, and has been for over 1\2 year. I no longer have a local dealership, and some on the forums think I have an air-idle control valve issue of some sorts that a dealership can flash and fix just like that. One of these days, one of these days.
I don't read much about the Vision CAN bus system. I think that is the electrical cannection inside of the compartment were the rear shock's air vavle is? I assume this is what they plug into the computer for the ECM?
Herb
Edited by g1nomad 2011-11-22 10:38 AM
|
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | the ECU reflash is by using Victory's digital wrench hardware/software. this can Not be done by a customer. and to be honest i think the ecu fuel map flashes are $hit anyways. i know because i had a s1l1 reflash on my 2008 vision and it barely did anything. if anything it ran worse.. then the service manager at the victory shop i went to told me that all the victory fuel maps have to meet EPA REGS which means they are going to be LEAN !! so even if they let a little more fuel in, they are still lean.. my vision(s) didnt start to run real good until i installed my power commander 5 ... i will No longer play with those Epa approved victory fuel maps. |
|
| |
|
Cruiser
Posts: 232
| Arkainzeye - 2011-11-22 2:39 PM
the ECU reflash is by using Victory's digital wrench hardware/software. this can Not be done by a customer. and to be honest i think the ecu fuel map flashes are $hit anyways. i know because i had a s1l1 reflash on my 2008 vision and it barely did anything. if anything it ran worse.. then the service manager at the victory shop i went to told me that all the victory fuel maps have to meet EPA REGS which means they are going to be LEAN !! so even if they let a little more fuel in, they are still lean.. my vision(s) didnt start to run real good until i installed my power commander 5 ... i will No longer play with those Epa approved victory fuel maps. Can you go into the PC5 detail alittle more. thanks |
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | TRELL - 2011-11-22 4:59 PM
Arkainzeye - 2011-11-22 2:39 PM
the ECU reflash is by using Victory's digital wrench hardware/software. this can Not be done by a customer. and to be honest i think the ecu fuel map flashes are $hit anyways. i know because i had a s1l1 reflash on my 2008 vision and it barely did anything. if anything it ran worse.. then the service manager at the victory shop i went to told me that all the victory fuel maps have to meet EPA REGS which means they are going to be LEAN !! so even if they let a little more fuel in, they are still lean.. my vision(s) didnt start to run real good until i installed my power commander 5 ... i will No longer play with those Epa approved victory fuel maps. Can you go into the PC5 detail alittle more. thanks
what do you want to know about it? ill try my best to answer questions you may have.
http://www.youtube.com/watch?v=tcgcost-mPs
Edited by Arkainzeye 2011-11-22 5:08 PM
|
|
| |
|
Cruiser
Posts: 232
| Thank You youtube vid explain to me what i needed Thanks for posting it..TRELL |
|
| |
ECU set up